production manager flexi 10 can't get packet

Like I said I have been searching and reading tons of posts about the problems and there doesn't seem to be a solution that I have seen. Cuts further cut still stop when cutting. changed the packet size to 1000 curve quality to medium. I can cut 20+ decals in other software and it wont cut 1 small decal without freezing half way threw it. I recently got FlexiSign 10 and it wont cut. I have used signcut for a year and have been using SignBlazer for a while now and no issues with either one of them. But I dont really think that is a problem. I seen someone mention about memory issues with the cutter not having enough. I have changes setting as others have described and all and it still does the same thing. Ill still put the anti static string on as another static fighter but so far it looks fixedīeen searching around for some answers to my problem aswell and seems to be a load with the SC Series Cutters and Flexi. So in closing, it looks like these simple things fixed my issue and the issue of a few others Ive read on here but never concluded on the fix. So with blade holder still out, I loaded some vinyl in cutter and sent same image again it pretended to cut whole thing without mishap as well. It pretended to cut the whole thing without mishap. $4.99, why not its worth a shot, so I ordered one.Īfter getting off the phone I took my blade holder out and resent the Scroll work image that the cutter with flexi froze on. He also advised about a, anti-static string they (cutterpros) sell that goes from side to side of cutter and drapes over vinyl and it pulls the static out as its being cut. Tech said its best to have it on 2 if possible and since I had nothing else on the comport list he switched it in my device manager to 2 as well as in my production manager set up for my cutter in flexi. So that was changed.Īnother thing was my set up was on Comport 4. Which I did find on USCutter support site but not knowing a lot about this I waited till Flexi support called me back. But all 3 images cut fine through SCALP.ġ thing we found in my set up was in my Device Manager in the comport for my cutter, flow control was set to 'none' and in Flexi Production manager it was set to hardware. Did this twice with 2 different Images (luckily it was cut piece and not full roll 2nd time). On another fairly simpler design, in middle of cutting it just cut a line in middle of material full length of roll ruining material and spitting it on the floor with rollers still going. A really detailed scroll work image just stopped mid cut froze with 'Now Cutting' still on cutter screen but 'write port error' In Production manager window. Well some of you may have seen Ive been having issues with my FLexiStarter10 and my SC Cutter.

Production manager flexi 10 can't get packet